833 OD sticking in 4th, chipped synchro

Thanks to you both. It's been so long since I rebuilt it (pre me digitally recording everything) I don't have a picture of what bearing is in the front. I dug out the receipt and the rings are wt307-14 quantity of 4. Unfortunately, the bearings were listed as RBK (rebuild kit) without any specifics on what bearing is in there. Again, I'll look to see when i take it apart. That will probably start tomorrow. I will experiment with lifting the cover in direct drive without the 1-2. I hadn't thought to do that. duh.

The 3-4 fork is not bent. It's a really good clue, I think, that there is a little wear on the outside (direct drive position) but no shine at all on the inside. It's like the slider wants to go inboard on that shift.