74 Dart 360 Sport
Managed to dig through my stash to finish the engine to harness. I will have to extend the mph sensor three wires and the ground to tank wire. Then hopefully I can get this all in and tested a bit. Main power harness is done. Since I won't need the grommet for speedo cable I think I may try to use to route my wires with the location. Will get the speedo sensor on it on and wired I will put a connector on there and wrap it. I'm going to avoid cremp connector and only use where needed. Least that way I can pull out easy for failure or replacement later. Need to start labeling all this white fiber tape maybe...not sure for this part. Time to lay down flu and strep
Managed to dig through my stash to finish the engine to harness. I will have to extend the mph sensor three wires and the ground to tank wire. Then hopefully I can get this all in and tested a bit. Main power harness is done. Since I won't need the grommet for speedo cable I think I may try to use to route my wires with the location. Will get the speedo sensor on it on and wired I will put a connector on there and wrap it. I'm going to avoid cremp connector and only use where needed. Least that way I can pull out easy for failure or replacement later. Need to start labeling all this white fiber tape maybe...not sure for this part. Time to lay down flu and strep