New Victor340 intake from Jegs
On mine there is no way to line the dividers of the gaskets up equally for both flange sides without having gasket overhanging into a runner.
Striking as best a happy medium in my case I slid each gasket equally so the short walls of the inner runners pretty much lined up and then the divider walls somewhat lined up, still off though. And then I needed to elongate the bolt holes about .090”
So on for runners 3/5/4/6 I have gasket slightly overhanging their long side walls about .058” I didn’t grind in the dividers other than enlarging the corners to match and roughing up the finish.
Shown below after ported,the windows opened up with the gasket placed approximately where it would lay without the bolt holes being elongated and how much the gasket sticks into the port. And the drill bit represents where the original holes are.
As mentioned earlier, your pics are what I saw with mine OOTB
The two Mr Gasket Ultra-Seal (5840) gaskets lined up on the flange using the bolt holes originally looked about the same as in your pictures.
On mine there is no way to line the dividers of the gaskets up equally for both flange sides without having gasket overhanging into a runner.
Striking as best a happy medium in my case I slid each gasket equally so the short walls of the inner runners pretty much lined up and then the divider walls somewhat lined up, still off though. And then I needed to elongate the bolt holes about .090”
So on for runners 3/5/4/6 I have gasket slightly overhanging their long side walls about .058” I didn’t grind in the dividers other than enlarging the corners to match and roughing up the finish.
Shown below after ported,the windows opened up with the gasket placed approximately where it would lay without the bolt holes being elongated and how much the gasket sticks into the port. And the drill bit represents where the original holes are.
As mentioned earlier, your pics are what I saw with mine OOTB