Making kickdown lever for carb

thebearded1 said
Yea it would have been simple if it was an easy metal to drill into haha. This stromberg is different then those but i will look to see if i get any ideas. The big issue is i can't take the lever off since it's rivets to the shaft or else i'd just make another lever and add it to the shaft

ok, how bout this...we tear the whole thing apart and pull out the throttle shaft

we then remove this little spacer (circled in red)

and replace it with one of these doohickeys

Stromberg 97-Style Center Carb Throttle Shaft Arm | eBay

put the whole thing back together

done
(some trimming required to clear the idle screw)