I'm 3D Printing a set of Dash Panels with Gauges

Trying a full print of the first piece on it's side....29% done and looking good so far. 28 hours left to go. I feel like the print will be successful, but due to printing on it's side there's going to have to be some cleanup and sanding at the very least, from the supports. I've had so much trouble with the soluble supports on this print I'm just going back to the old fashioned way of no fancy support material. But that means the surface where the support touch the print is going to be a crapshoot. Anyway, I'll check in on Friday with an update.


Screen Shot 2023-01-26 at 12.04.04 AM.png