Easiest 727/904 rebuild thread...
So here's where I'm experimenting a little I got the pump cleaned up and I'm pointing at the machine service on the outside of the pump and the brass bushing on the inside of the pump. Both of which I took the lightest buff of 600 grit wet and dry sandpaper just to get a shine on them not sand them down but just get them smooth and clean...
(Hack job should be just about losing his brain about now LOL...)
Of course I don't recommend any of this rebuilding your transmission I would just change the bushings and get new parts...
Also I dug through some of my parts and found a nice tail house bushing I also got on the tail shaft and just cleaned up the bearing which that was $59 forget that...
Again if this was a keeper I'd buy the back bearing and I'd buy new pump gears for $20..
So here's where I'm experimenting a little I got the pump cleaned up and I'm pointing at the machine service on the outside of the pump and the brass bushing on the inside of the pump. Both of which I took the lightest buff of 600 grit wet and dry sandpaper just to get a shine on them not sand them down but just get them smooth and clean...
(Hack job should be just about losing his brain about now LOL...)
Of course I don't recommend any of this rebuilding your transmission I would just change the bushings and get new parts...
Also I dug through some of my parts and found a nice tail house bushing I also got on the tail shaft and just cleaned up the bearing which that was $59 forget that...
Again if this was a keeper I'd buy the back bearing and I'd buy new pump gears for $20..