'70 Dart 392 Project; what direction?
Few more small things done.
Got my rear axle/leafs/shocks all torn out ready to start minitub next week.
Headers are torqued on.
Starter ordered.
Added a 4th wheel on my engine dolly.
Installed McLeod hydraulic TO bearing, and got my plugs/coil packs installed and got my shifter linkage mocked up. Everything shifts good but I’ve got a HURST shifter that I might rebuild and swap in.
FYI the TO bearing will NOT fit through the bellhousing I put shaft hole. You have to take bellhousing off block after taking measurements and install on trans before installing TO bearing. Contrary to what the instructions say :)
Progress is progress!
Few more small things done.
Got my rear axle/leafs/shocks all torn out ready to start minitub next week.
Headers are torqued on.
Starter ordered.
Added a 4th wheel on my engine dolly.
Installed McLeod hydraulic TO bearing, and got my plugs/coil packs installed and got my shifter linkage mocked up. Everything shifts good but I’ve got a HURST shifter that I might rebuild and swap in.
FYI the TO bearing will NOT fit through the bellhousing I put shaft hole. You have to take bellhousing off block after taking measurements and install on trans before installing TO bearing. Contrary to what the instructions say :)
Progress is progress!
