a903 , a230, a833 , a833od

Yes those all **should** take the Same part for the TOB.
All Are the same Snout Diameter except for the Hemi 18 Spline input Shaft which has a Different TOB.
May I recommend the Hays 70-110 TOB. for this install. Why do this job again due to questionable parts quality?

The parts store parts and rockauto may have vague quality or have Plastic Sleeves or parts on them.

Alternatively, you can reuse your existing sleeve and just buy the Bearing separately and have it pressed on.

I dont have any clutch Kits part #'s handy for a slant 6 on hand. If it's a stock motor than any quality Clutch and PP set should do.

You can always have your parts rebuilt by falcon clutch or kentucky clutch too.


Cheers!