Wheel studs and spacers with Bullitt rims
I’ve run the bull it rims on my duster from American muscle since 2009. In fact I’m ready to change it up again. I have no spacer on the front with the 5.72 bs whees.
The rear I’ve run a few different setups.
I had the stock 8-1/4 with an adapter/spacer. Then I went to a b body 8-3/4 which I think required a 5/16 spacer. Then I went to the explorer 8.8. At some point I did the offset hangers, I don’t remember if that was with the b body 8-3/4 or just the explorer 8.8.
Then I went to 10.5 wide bullit with 315s.
It took some creativity to get them to work, but they work.
I’m older and kind of over the stuff pro touring ride and the look. I’m going back to old school street/strip setup. Your can see the 315s here