New hammer what will it run?

MHEAD said

I don't really enjoy building them after about the third tube I get bored.Spintek used to make 1 7/8×3" for later Dakotas and was told they may work on the earlier ones but not sure.
I considered the s10 headers and just weld mopar flanges on them but the s10 I saw them on engine compartment is way different.
I used the stock four cylinder five speed transmission cross member.

Click to expand...

I understand what you are saying about the headers. It looks like I am going to have to build a set myself for my dakota and I can't fab for crap. I remember the spin tech headers. Bit it looks like they only make them in mid length now. I was asking about the cross member. Because I found out if you Rdrill two mounting holes on the left side, that the new holley black hart transmission cross member that was made for installing a gen3 hemi. Will work with a LA/ Magnum engine. It let's you run a duel exhaust system with it hacking up the crossmember. When I decided to try some 18 inch header exstions on my 91. There was no way of getting them to work with out hacking up the factory crossmember. The holley you can buy different mounting plates to use 904/727 / 5-6 speed stick/ 8 speed auto etc.