Victor340 and RPM manifold testing
Ok guys to finish up this post I wanted to test a very nice Wilson spacer that the customer sent that I forgot to test. But yesterday I quickly tubed the one head bolt on this TrickFlow head and spent 20 minutes on it porting it some. I found the 10 missing cfm and it’s at [email protected] and [email protected] then slightly drops at .700. I know what I have to do next but I have to get moving on a set of Speedmaster heads today. The Wilson spacer was worth I’m going to say 3 cfm in the .400-600 lift range but their main job is to assist fuel distribution not necessarily flow. Kinda out of my budget but I like it and would like to possibly buy one someday. Being I’m dumping more alcohol than the gas guys it would probably be a good test. Here’s a few pictures of it.
Ok guys to finish up this post I wanted to test a very nice Wilson spacer that the customer sent that I forgot to test. But yesterday I quickly tubed the one head bolt on this TrickFlow head and spent 20 minutes on it porting it some. I found the 10 missing cfm and it’s at [email protected] and [email protected] then slightly drops at .700. I know what I have to do next but I have to get moving on a set of Speedmaster heads today. The Wilson spacer was worth I’m going to say 3 cfm in the .400-600 lift range but their main job is to assist fuel distribution not necessarily flow. Kinda out of my budget but I like it and would like to possibly buy one someday. Being I’m dumping more alcohol than the gas guys it would probably be a good test. Here’s a few pictures of it.