Rocker Shafts
Pretty much not to wide, or deep. You don’t want to let the groove go outside the confines of the rocker body or you will lose your oil pressure for oiling the rocker.
Th deep is an obvious problem cause you’d put a hole in the shaft.
But this is what we did. I just used an angle grinder and a steady hand if I remember correctly.
Hope this helps. Prorac1
Pretty much not to wide, or deep. You don’t want to let the groove go outside the confines of the rocker body or you will lose your oil pressure for oiling the rocker.
Th deep is an obvious problem cause you’d put a hole in the shaft.
But this is what we did. I just used an angle grinder and a steady hand if I remember correctly.
Hope this helps. Prorac1