Making some slow but steady progress. I made a bracket setup for the throttle and kickdown cables and the return springs. The 2 barrel carb drives nice and has a lot more pep. The next warm day I will take it down to my "testing grounds" and use the Drag Racer app to see if i turn a better 1/8 mile time.
View attachment 1716060463
I made a bracket for the seat belts too. It's hard to see in the photo but it's 1/4" steel with gussets for the tabs. There is another piece of 1/4" steel the same width and length on the backside of the body. The 2 pieces sandwich the back body using 7/16" grade 8 bolts. Later on when I add a roll bar that is tied into the frame i will tie this bar into the roll bar. I'd eventually like to run this car at one of the Loring Timing Association's land speed events in Maine to see what it will do which is why I want to add the rollbar. I will have 4 point seat belts in it by then too.
View attachment 1716060464
Last night I upholstered the seat back. It's 4" foam with badding attached to 1/4" birch plywood. I will screw another piece of 1/4" plywood to the body and use velcro to hold it in place. I was even able to get the stripes to line up! Now I'm going to make a thinner pad at the top to help fill in the gap between the body lip and seat back. It will be 2" foam and tan fabric.
View attachment 1716060465
View attachment 1716060466