Dual quad info
Bit by bit...got the primary carb from Jim Ward with help from Todd, S'cuder. And advice from Str12340.
I measured(ballpark) the throttle shaft to car stud, 1.2", so 1/3 of that is 0.4.
Measured that on front carb and drilled 3/16 hole. Machine screw and washers and I think I've got it! :thumbsup:
I'll enlarge the 3/16" hole so the front carb stud is sturdier. May also put a "sleeve" of some sort over the threaded part of front stud.
Bit by bit...got the primary carb from Jim Ward with help from Todd, S'cuder. And advice from Str12340.
I measured(ballpark) the throttle shaft to car stud, 1.2", so 1/3 of that is 0.4.
Measured that on front carb and drilled 3/16 hole. Machine screw and washers and I think I've got it! :thumbsup:
I'll enlarge the 3/16" hole so the front carb stud is sturdier. May also put a "sleeve" of some sort over the threaded part of front stud.