'69 Barracuda T56 swap, floor, cross member
Next was to get the AMD cross member to fit.
NOTE Torsion Bars must be in place to insure alignment of cross member. There is no forgiveness with torsion bars if cross member angle is off even a hair then torsion bars won't go in.
The cross member mount tabs where it meets inner rocker panel required extensive bending, shaping, forming in order to get them to lay flush against inner rocker. I taped card board to cross member to mark where inner rocker was located, removed cross member, bend tabs, and repeat over a few days time frame until I got a nice snug fit. I search and others replaced their cross member but no one said anything about having to monkey around with those mount tabs to get a good fit. So don't know but I was not going to settle for some sloppy fitting frame structure.
Next was to get the AMD cross member to fit.
NOTE Torsion Bars must be in place to insure alignment of cross member. There is no forgiveness with torsion bars if cross member angle is off even a hair then torsion bars won't go in.
The cross member mount tabs where it meets inner rocker panel required extensive bending, shaping, forming in order to get them to lay flush against inner rocker. I taped card board to cross member to mark where inner rocker was located, removed cross member, bend tabs, and repeat over a few days time frame until I got a nice snug fit. I search and others replaced their cross member but no one said anything about having to monkey around with those mount tabs to get a good fit. So don't know but I was not going to settle for some sloppy fitting frame structure.