locating leaf spring sliders
Looking at this picture, it looks like you have the slider 4 inches from the rear mount to the front of the end of the roller stop. Is that correct or am I looking at it wrong?
I‘m trying to get the slider located properly with no weight on the springs.
If I have your numbers wrong, how far forward should the end of the front of the slider slot be from the vertical mount??
TIA
Yeah the bracket just bolts to the original shackle mount. With the slider even with the bottom of the frame horn the car ended up about 3/8” lower than with the stock shackles.
The bracket itself is just a 3”x3" x.125" tube cut at an angle with an 3/16” plate welded to the bottom. If I had it to do over again I'd make the bottom plate 4.25" long and cut a little different angle on the tubing, the slider ended up a little further forward than I'd planned. It is also offset a 1/2" to match my 1/2" offset DoctorDiff front hangers.
View attachment 1715653669
Calvert also makes springs sliders with a built in angle. Best practice would be to have the slot in-line with the angle of the leaf spring. The AFCO sliders I used have a flat slot, so ideally I would have built a bracket with a little angle. Or used the Calvert's, although the angle they use is generic.
Looking at this picture, it looks like you have the slider 4 inches from the rear mount to the front of the end of the roller stop. Is that correct or am I looking at it wrong?
I‘m trying to get the slider located properly with no weight on the springs.
If I have your numbers wrong, how far forward should the end of the front of the slider slot be from the vertical mount??
TIA