Hughes Engines 1.6 Rocker Geometry/Setup
I was referencing post #33 and his ridiculous comments
This is my point of having you Yahoo on ignore and the reason why... You make stuff up and take off with it...
That was balance? Degree cam? Meaning why are we talking about that when the subject was rocker geometry?...
But you being a Yahoo grab balance and degree and run off at the mouth about how I say not to do that. You mean don't do as I do and degree my cam and have my rotating assembly balance?...
I'm glad I unlocked this page so I could confirm why I have "you people" on ignore...
I agree with Rusty rat rod everything should be checked.. good for what the lp is looking for and has in place is it 100% necessary?.. that's up for him to decide but I recommend having things at least within tolerance again for his purposes...
Hughes 1.6 to 1 rockers that were nailed directly down with no shins to my factory heads and no problems but that was just my luck I guess.. (if that is the subject we're talking about.…) Simply just my experience with what the op was asking for... Not a recommendation just my experience...