Crane Rocker arm clearance on Iron heads issue
Ok my Dad said to check the thickness of the inner pedestals and I think they are the culprit. The good side shows' them to be more centered. The side in question the numbers are not so symmetrical.
Good side:
Side in question:
The picture with the measurement of 0.319 is the rocker that is rubbing.
So I am coming to the conclusion that all I will need to do is shave a little bit off of that pedestal and I should be good?
Ok my Dad said to check the thickness of the inner pedestals and I think they are the culprit. The good side shows' them to be more centered. The side in question the numbers are not so symmetrical.
Good side:
Side in question:
The picture with the measurement of 0.319 is the rocker that is rubbing.
So I am coming to the conclusion that all I will need to do is shave a little bit off of that pedestal and I should be good?