'69 Barracuda T56 swap, floor, cross member
Went back over all the welds on cross member and front frame rails, added some welds, ground down and rewelded, welded-up/finished lower inside corners of T56 center section ect. Vacuumed out frame rails started to get things cleaned up.
Will need to do more wire-wheeling/sanding surface prep. Then clean garage and car, completely remask car, and Epoxy and Weld Through primer all the surfaces.
But....the messy dirty dust storms labor intensive rust repairs are done at this point....now when I look inside the car much better on the eyes....
Went back over all the welds on cross member and front frame rails, added some welds, ground down and rewelded, welded-up/finished lower inside corners of T56 center section ect. Vacuumed out frame rails started to get things cleaned up.
Will need to do more wire-wheeling/sanding surface prep. Then clean garage and car, completely remask car, and Epoxy and Weld Through primer all the surfaces.
But....the messy dirty dust storms labor intensive rust repairs are done at this point....now when I look inside the car much better on the eyes....