Small Block Showroom!
What are the specs on that 568hp stroker? Those are the numbers I'm after.
I asked the builder for a reliable high-performance street engine that runs on 91 octane, and has a smooth idle.
0.060 over magnum 360 block. 4.125 stoke crank. Crank is made by K1, but I don't think K1 makes that stroke any more, so you would need to find another manufacturer.
Ported Eddy magnum heads, 308 cfm at 0.50 lift.
10.2:1 compression ratio.
Molner rods. Diamond pistons. Hastings rings. Morel lifters.
Indy intake with 1" carb spacer. Holley 1000.
TTi 1-7/8" headers
Comp hydrauilic roller. 0.586 in/ex lift with 1.6 rockers. 112 lobe separation. Durations at 0.50 lift are 242 in/248 ex
MSD ready-to-run distributor. Best HP was at 31 degrees timing
568 HP at 6,000 RPM, 545 Ft-Lbs @ 4500 RPM
Just for fun, we also tried some other intake/carb combinations: Eddy air gap rpm with Eddy 800 carb produced 534 HP and 544 ft-lbs . Eddy air gap rpm with Holley 1000 produced 550 HP and 559 ft-lbs.