Closed chambers gone bad… that’s a wrap
Had a chance to measure each piston at TDC threw the numbers below, thinking I’m going to run .090 head gasket should get me close to the .040 quench going off the tallest piston. Crazy the numbers are all over the place for pistons that should be .018 above top deck.
Included a bunch of photos of heads and holes giggity! Happy Memorial Day friends.
#2= .045”
#4= .053”
#6= .047”
#8= .040”
#1= .027”
#3= .018”
#5= .025”
#7= .022”
All measurements taken from right below the valve relief slightly off center to not get into “bullet casing” these pistons are annoying for that reason.
Had a chance to measure each piston at TDC threw the numbers below, thinking I’m going to run .090 head gasket should get me close to the .040 quench going off the tallest piston. Crazy the numbers are all over the place for pistons that should be .018 above top deck.
Included a bunch of photos of heads and holes giggity! Happy Memorial Day friends.
#2= .045”
#4= .053”
#6= .047”
#8= .040”
#1= .027”
#3= .018”
#5= .025”
#7= .022”
All measurements taken from right below the valve relief slightly off center to not get into “bullet casing” these pistons are annoying for that reason.