Turn a small drill press into a Bore/ Hone. Bolt it to the top of your engine block & do your own machining .

Moparofficial all good points.
I had to great ideas.
1) There is a local place that does pottery. I was wondering if i could strap a block to the table that spins and hold stationary Precision Cut Wood, cylinder size wrapped with wet or dry sand paper, then spin the block to hone it.
2) I was watching a episode of Gillian Island. The batteries were dead in the radio. So it gave me the idea.

The professor made a bike from bamboo and coconuts. I could get a used exercise bike from Goodwill, attach a hone to it.
Make a jig to hold the block in place.
I am going to call it "Side-Hone" since the block will be on it's side
And have a 100 percent off grid machine shop.
Maybe get some kind of Goverment grant since 100 percent green! And build more quality equipment equivalent to any machine shop