'67 Valiant 2 door sedan for Drag n Drive
Here is a photo of the passenger side wheel tub approximately clamped in place prior to final fitting. Gives you a better idea of the shape I wanted, compared to the usual curved tubs...
The trunk floor was pretty simple, just needs a couple of custom shapes to seal up all the openings.
I put a little pattern shape in the flat panels with the bead roller to give them some added strength and reduce the rattles.
Here's a look at the trunk floor before it was welded in place. The 15 gallon fuel cell is mounted in the center. The battery (or batteries) will go on the right side. I had to make a support bracket under the sheetmetal to support it and provide a good anchor for the battery hold downs.
Lot's more to come... gotta finish the roll cage too...
Here is a photo of the passenger side wheel tub approximately clamped in place prior to final fitting. Gives you a better idea of the shape I wanted, compared to the usual curved tubs...
The trunk floor was pretty simple, just needs a couple of custom shapes to seal up all the openings.
I put a little pattern shape in the flat panels with the bead roller to give them some added strength and reduce the rattles.
Here's a look at the trunk floor before it was welded in place. The 15 gallon fuel cell is mounted in the center. The battery (or batteries) will go on the right side. I had to make a support bracket under the sheetmetal to support it and provide a good anchor for the battery hold downs.
Lot's more to come... gotta finish the roll cage too...