1965 MMP's Barracuda Hemi swap! The Ever Changing Build

Ok so have to pickup new hardware for the intake manifold today. I got a couple gallons of hi-test fuel. Need to test and install injectors then prime and test fuel system for leaks. Cleaned up under the dash last night. Only have a few wire for the efi harness to finish and ground for the gauge pod. Going to rewire my fan and tach system I have mounted in my glove box ( clean up and trim ) need to run power to my center console and a ground for my (Sport mode) button... ooh so fancy :D. Than I can power up the system (efi) and test the brake lights and reverse lights may have to install solenoids for them, just in case I ran two extra grounds and have a setup ready to go in. I'm hoping to have this all finished and a full systems check done this weekend.

Forgot: I need a new heater fan switch the one I have is toast ugh...