My only thing is I don't like things moving if I could possibly be underneath them! Lol, I've jacked up two-story buildings with a roof load on top of that, with me as the only person underneath there, and no one else around, replacing the bottom floor load bearing walls. I don't know the exact situation of what happened over there, I'm just glad you're not hurt! however if I had a vehicle on its side with a shop crane, I'd probably tapcon a 2x4 behind the back wheels just so that thing couldn't slide backwards at the Worst Time.... Glad you posted this thread man, that's a wicked looking motor Brother! Along with the rest of Your Build! I may be confused, but I thought you were going for a 10-second cage at first? I'm glad you're going to have it rated tat 8.5 though, that gives you room for improvement, laugh out loud! That being said, is that the same motor that you had on the dyno a few months ago? or did y'all decide to rip that down and just go back through it? If there were any issues, I'm glad you guys caught it before it caused catastrophic engine damage or other things...