Lower control arm pin/bushing install

Well that didn't work. But I did finally get it with a ball joint press and a 2lb mini maul. It's a little bit short but the press will just barely catch the shoulder of the pin. This is still not going to work. So I took a thick washer from a strut rod and first made the hole large enough to slide onto the pin all the way to the shoulder. Well you can't get the press on the pin and the lca with the washer on the pin. So I cut a v notch in the washer so I could wedge it between the press and the shoulder. Very tight fit and things weren't lined up. That's where I used mini maul to persuade it to do what I wanted. Then I was able to use my impact wrench to press it in. Would have been easy with a big enough shop press but I didn't know anyone that had one. It worked that's all I care about. Hope I never have to do it again. Maybe this will help somebody out there