Magnum 360 build. (HP/tq?)
Yes :) but so is guessing out of thina, but yes there's variables.
“Thina?”
Your reply was off base and half way to insane & here’s why I think your response should not been.
“What rpm do you think peak hp will happen at?”
You’re asking someone asking us because he doesn’t know where leak torque is going to happen? This is stupid. How can you ask a guy this very question when that is his question?!?!
Unbelievable!!!!!
“Say 5500 rpm you can kind of figure it out, an average guy build is gonna make 1.15 to 1.25 lbs-ft per cid so say 1.2 average x cid = 438 peak tq.”
How do you get peak torque at 5500? There is absolutely no basis to get this number but only through assumption.
“tq at peak hp averages 90% of peak tq so 394 tq x 5500 rpm / 5252 = 413 hp @ 5500 and 438 tq around 1000-1500 rpms lower.”
Again, only under gross assumptions can this work.
You have no idea of head flow, exhaust flow, header size, cam duration @.050 or advertised or the overlap. Is this an LA cam or a Magnum cam…. Ground on what lobe series?
What size carb is he using?
Your making guesses through assumptions.
And the. You defend it and even worse you drag GTX John into this? Dang! You got some balls kid. Some set of balls dragging GTX John into defending you and using his guess as a crutch as a defense on being correct.
Un-freakin-believe- ABLE!
GTX Johns guess = would have 1.23lbs-ft Tq per cid and peak hp around 5500 rpm to workout mathematically.
If you assume a lot of factors. And you did.
And now I see you blaming GTX John?
WTF?
Is this a “Anything to be in the right” thing for you?