'69 Barracuda T56 swap, floor, cross member
Removed the stacked 6x6 lumber that was supporting car under the rocker panel and put two jack stands under front rails. Both doors were very happy opening and closing very nicely alignment body gaps very good.
Test fit sub frame connectors. It took a bit of force with the RV jack stands to get them all the way up to the floor. But once up there minimum gaps, both doors open and close nicely, and body gaps look good. Took a lot of time to get them wiped down get all the oil and black crud off them. Masked up where weld through primer will go and shot two coats of PPG Epoxy Primer on them both inside and out.