Here we go again
OK, how dare I forget "port matching"!
This was a Ford Racing (Edelbrock) head that I matched to a RPM intake for a 331 build. Quite the mismatch going INTO the head! Pulled over 300HP at the rear wheels at a modest 4000ish rpms, a very well mannered street engine. Hoping to do similar for my 340, so this is a good post to see some results hopefully!!!
Apparently my camera broke before I could take pictures of the finished intake port, OR the exhaust ports.....sorry, no pic's there!?? I think my brain broke.....duh! To much aluminium dust....
Steve
OK, how dare I forget "port matching"!
This was a Ford Racing (Edelbrock) head that I matched to a RPM intake for a 331 build. Quite the mismatch going INTO the head! Pulled over 300HP at the rear wheels at a modest 4000ish rpms, a very well mannered street engine. Hoping to do similar for my 340, so this is a good post to see some results hopefully!!!
Apparently my camera broke before I could take pictures of the finished intake port, OR the exhaust ports.....sorry, no pic's there!?? I think my brain broke.....duh! To much aluminium dust....
Steve