1972 Dodge Colt
Worked on linkage a little.
That should tighten up real good.
I am also changing my master cylinder on the hydraulic clutch.
I had rebuilt the Airheart cylinder that was on the car when I got it.
It had a small leak and I wanted to make sure that the clutch was not creeping.
Tolomatic still sells the same cylinder, only plastic not aluminum.
Went with a 3/4 bore to replace the 7/8 bore.
Just need to bleed it after the trans goes back in.
Worked on linkage a little.
That should tighten up real good.
I am also changing my master cylinder on the hydraulic clutch.
I had rebuilt the Airheart cylinder that was on the car when I got it.
It had a small leak and I wanted to make sure that the clutch was not creeping.
Tolomatic still sells the same cylinder, only plastic not aluminum.
Went with a 3/4 bore to replace the 7/8 bore.
Just need to bleed it after the trans goes back in.