Indy 360-1 vs Edelbrock RPM heads
Rumble is this the way they came from Hughes with any other modifications { valve job, port grinding etc. } ?
Box stock! I fit in a set of Lunati solid roller springs, outside springs only. When you see the video, what you is what you get from them.
Overall, not bad. Not great ether. I’d stick’em under a 414 (or greater) & the best intake you can get, which, IMO would be something like a good tunnel ram, not the old Edelbrock unit or an Indy intake or a well done super Victor. At the minimum, a well prepared Victor.
I’ll try several intakes for my own enjoyment. Some call it dumb, weird, but! Because I do weird stuff, you’ll know. Pittsburgracer ported a single plane M1 for me with nice results. I have a 1,000 TQ. Not a combo you ever see. So, that’s why I’ll try it. Good, bad, indifferent, home run? Failure? IDK, nor do I care. I just like trying stuff out. It was the only way to learn pre internet and I had a ton of doing it I just gotta get back into screwing around again. Best way to learn, get greasy baby!!!!
Rob, what was the bore size for that test?
Also, not sure the OP knows this, but the BM heads require offset intake rockers.
Hey PRH, at the moment, I don’t remember. I’ll post it up when I speak with Charlie next. I know I posted this before… wait… I think I did. Fudge! Now I’m not sure, I’ll check with Charlie.