rumblefish360 said

Right! Big port up front is for the PVC.
The big one at the rear is for the power brake booster. The large port seen on the front in my picture IS from the space HOWEVER where my fat finger is a small 1/8 full vacuum line from the carb base. This is noted by Holley as the “PCV” vacuum line. Its freaken 1/8” is that ok for the PCV?

Click to expand...

rumblefish360 said

Do not share or splice the hose together. Always run them to each respective port.

The spacer is probably helping with HP. If you remove it, you may, MAY notice a power loss. I doubt it but it’s possible. Open spacers normally add top end power. At least on single planes with open plenums. Like the M1.

Click to expand...