Engine stalls when turning

512Stroker said

Al, my set up was way to rich on the primary side.
Ended up drilling an .100 hole in each of the primary plates to lean it out.
That did the trick

Click to expand...

It's Rob, but that's ok. You didn't call me "asshole" so most anything else is acceptable. LOL

Wow. Usually drilling the plates is extreme, although it does work. You don't think you could have leaned it out with the metering rods and springs and jets? So leaning the air screws didn't put an end to it? Did it help at all? Thanks for responding so quickly.