Front Hub Diameter for 65 Barracuda - Are there differences between 6 and 8 cylinder?

Thanks Professor Fate. I'll really old. I remember MOPAR LH/RH stud/nut issues:thumbsup:. Nuts were off. The only way I could get the wheels off without bending them was to put jacks between wheel and frame, front on rear of the wheel, apply gentle pressure while banging the backside of the wheels with a softer faced 5 lb dead blow hammer. Then once off, you can see the witness marks where the wheel center was "pressed" onto the hub about 1/8" away from the drum face, and keeping the wheel from fully seating against the drum. This was due to the hub being larger than the wheel center. Yet, the drum/hubs are 5x4" pattern. The only car I know of using that pattern is the early A bodies.