'69 Barracuda T56 swap, floor, cross member

Test fit the rear seat to verify the seat bracket placement on the new floor pan. I then used 3M Panel Bond to glue the seat brackets to the floor pan.

The rear seat mount bolt hole, on the rear of the seat passengers side, had to be re-drilled in the floor pan about 1/3 inch up higher then the original hole. Took several hours of putting in seat, taking out seat, climbing in and out of the car repeatedly, scratching head, measuring, measuring some more, and more measuring to be sure. Apparently the original seat was in the car slightly crooked which was why the original bolt hole was off. Anyway got that all sorted out so I know later after paint work etc rear seat will fit correctly.

Rear seat brackets 1.jpg

Rear seat brackets 2.jpg

Rear seat brackets 3.jpg