'69 Valiant 2DR Project
I hooked up some wiring things, just temporarily, to get power to the engine harness, ECU, ignition switch, and starter. Starter spins up and the ECU powers up properly. I don't have the torque converter in, so it doesn't kick the engine over. I still have to pull the trans to install the TC and valve body. I hooked up the laptop and loaded a tune file today, found some issues with the MAP, MAT, and CTS sensors. The MAP connector is wired backwards so it's pinned to a high reading. The MAT and CTS sensors are two wire thermistor sensors, so I'll have to do some research on how to test those sensors and wiring, they are reading Low Error, same reading when unplugged. I really hope it's something simple as I really don't want to have to send this ECU back. I also got a new rad, 12" fans and shroud that need some customizing. The shroud needs to be trimmed in a couple of the corners to fit like I want it and AN bungs welded for the inlet and outlet. I have some brackets for the rad mounts being laser cut so hopefully I'll have those this week.
I hooked up some wiring things, just temporarily, to get power to the engine harness, ECU, ignition switch, and starter. Starter spins up and the ECU powers up properly. I don't have the torque converter in, so it doesn't kick the engine over. I still have to pull the trans to install the TC and valve body. I hooked up the laptop and loaded a tune file today, found some issues with the MAP, MAT, and CTS sensors. The MAP connector is wired backwards so it's pinned to a high reading. The MAT and CTS sensors are two wire thermistor sensors, so I'll have to do some research on how to test those sensors and wiring, they are reading Low Error, same reading when unplugged. I really hope it's something simple as I really don't want to have to send this ECU back. I also got a new rad, 12" fans and shroud that need some customizing. The shroud needs to be trimmed in a couple of the corners to fit like I want it and AN bungs welded for the inlet and outlet. I have some brackets for the rad mounts being laser cut so hopefully I'll have those this week.