Door alignment/adjustment

I am working on my 73 Dart Swinger, I have the passenger door pretty much aligned. Body lines line up good, it sits just a little high in the rear, but there are no guts in the door. My question is about the lower rear of the door. That lower rear corner of the door seems to curve in too much, so when the rest of the door is flush, it is 1/16"-1/8" inside the quarter panel.

Do I try to readjust the door, moving the lower section out? (this will probably throw all other gaps and edges off)

Or do I dare try to move the door edge out slightly with a hammer & dolly?

This is not going to be some 100 pt show car, so maybe I just leave it alone and assume I am the only one that will notice?

What are your thoughts?

Thanks,
Aaron