Jeep 4.0 in 69 Barracuda
Yeah I can get it up on jackstands after MoParty. Probably sometime in the first of the week
Dude, I owe you.
I remember you talking about having the slammer kit. Is the K-Member configuration different, or just the addition of the lowering knuckles?
The center of the joint of the idler arm measures 5in off the inside edge of the passenger sub chassis. And my starter is no more than 3 in in diam.
If i am not mistaken, the HDK configuration has the steering rack behind the center line of the knuckle spindles. I also need to know measured from the K Member mounting pads, how far below is the steering rack. I can use that measurement to guage if my engine will hit the rack at its current setup.
I am going to assume the lower control arm bolts sit under the chassis rails. So if we can determine that the area needed for the starter is clear, then I am golden. The cross support bar may need to be re worked if its required. Thats something I can work with hdk on.
I am also looking at QA1, much rather go thru HDK. But at this point, its what ever solution gets my project moving forward with out just throwing a stroked slant 6 in.