Edelbrock heads with OEM manifolds
I ended up doing a slight blend at the sharp edge.
And then ground the exhaust. I blended the ports (port matched) had a friend's shop surface them, so they would be square and flat. They need to be ground from cut from the millling mark down. I did so little at a time untill I had clearance but used header gaskets between the heads-manifolds.
I ended up doing a slight blend at the sharp edge.
And then ground the exhaust. I blended the ports (port matched) had a friend's shop surface them, so they would be square and flat. They need to be ground from cut from the millling mark down. I did so little at a time untill I had clearance but used header gaskets between the heads-manifolds.