'69 Barracuda T56 swap, floor, cross member
@72bluNblu The bolt on the top of the trans is pressed hard up against the floor. The edge of the bellhousing is pressed hard up on the floor. The floor is pressed up onto the heat duct. The floor up to pinch weld has been removed just the firewall metal is left. I am going to pull that plastic off to get a better look next time I get out there:
The bottom edge of the trans is contacting the trans cross member. But I could slightly clearance the cross member to get around that issue:
Here is a side shot to show location of shifter relative to trans cross member. Offset arm is 2.75". Trans looks further back to me then other installs I have seen:
@72bluNblu The bolt on the top of the trans is pressed hard up against the floor. The edge of the bellhousing is pressed hard up on the floor. The floor is pressed up onto the heat duct. The floor up to pinch weld has been removed just the firewall metal is left. I am going to pull that plastic off to get a better look next time I get out there:
The bottom edge of the trans is contacting the trans cross member. But I could slightly clearance the cross member to get around that issue:
Here is a side shot to show location of shifter relative to trans cross member. Offset arm is 2.75". Trans looks further back to me then other installs I have seen: