Boosted slant?

Don't know the numbers of the cam I have in mine duration wise off the top of my head, have the sheet in the house by the desktop computer
All I know of hand is I have a Oregon cams 819 in there right now. I hope if I decided to go thru with the turbo it'll work. I remember when I was building this engine (long thread both on here and the /6 forum from about 2 years ago) people were saying I should use one with a different lobe sep angle (wider) than an but I'm hoping that for my purposes what I have now will suffice.
Just curious where your block is cracked.
I built a 63 /6 about 30 years ago and only found out it's block was cracked horizontally, a little above the oil pan rail and right behind the PS pump a crack about 3" long. Had no idea until it was all back together and running again. Then it started to seep when engine was hot and radiator was under pressure. I wasn't happy. But that was also the car that I totalled 700 miles after I put that engine into.
I wound up pulling the head and putting it onto my dad's car and the freshly rebuilt (albeit cracked) short block went to the junkyard with the crinkled body