4 speed/G3 hemi

I ran an 833 behind my 5.7 when I first installed it. I believe I had to trim the input shaft down something like 1/2-5/8", but otherwise it was basically a bolt in setup. I ran it with TTI headers as well, but I think I had to do some modification of my Z bar linkage. I'm not sure I ever had the correct Z bar in it to start with though as my car was a junkyard special when I bought it. I've since swapped to a T56 with a hydraulic clutch though, so don't have anything I can look at again for pictures unfortunately.