Another set of Edelbrock heads on the bench
These belong to a friend that had a friend port them for him. He was lead to believe they had 2.055 valve in them but they are 2.02 valves. 2 of the 8 intake pushrod holes were tubed and some porting work goes in about 1.5 inches. Some shortside polishing was done. Reversion was terrible especially for an alcohol engine. A three angle valve job was done. Intake valves are shot but we are jumping up to a 2.055 valve. The exhaust valves look terrible and I’m guessing will be replaced. These are going on a shelf awaiting their place in line but I wanted to be able to order parts. I knew where I marked turbulence they were going to start backing up and they did fast and hard.
These belong to a friend that had a friend port them for him. He was lead to believe they had 2.055 valve in them but they are 2.02 valves. 2 of the 8 intake pushrod holes were tubed and some porting work goes in about 1.5 inches. Some shortside polishing was done. Reversion was terrible especially for an alcohol engine. A three angle valve job was done. Intake valves are shot but we are jumping up to a 2.055 valve. The exhaust valves look terrible and I’m guessing will be replaced. These are going on a shelf awaiting their place in line but I wanted to be able to order parts. I knew where I marked turbulence they were going to start backing up and they did fast and hard.