So, I am on to the next project. Need to get the 70 Cuda on the rotisserie. The rear brackets mount at the rear no problem. But the front brackets from the rotisserie that were used on a 68 roadrunner will not match the holes on the frame rails for the 70 Cuda. As you can see in the picture, the two holes in the rotisserie bracket are in line. The two holes for the Cuda are offset. I think I know what to do but I am asking some of you here who have better fabrication skills than I do, what would you do? I got these quarter inch steel plates. I think the best way is to weld them to the inside of the existing rotisserie brackets and redrill the lower hole through, and drill a new hole for the front higher, approximately where my thumb is. What say you fabricators?
View attachment 1716159564
View attachment 1716159565
View attachment 1716159566
View attachment 1716159567