Lower Control arm Tools

You also can use a die grinder to split the outer metal case of the bushing carefully, similar to the sawsall method mentioned in the above post.

I recently tried the washer method, but the steel was soft and kept tearing out until I had no more material to weld onto so I ground a slit into part and then was able to hammer and chisel it out fine.
Be careful to not grind too deep on the shell as mentioned above, you just want to get it thin, a lot like removing an exhaust pipe from inside a muffler that you wish to reuse.

Not as easy as using the proper FSM recommended tool, but it got the job done just fine.