'69 Barracuda T56 swap, floor, cross member
Finished welding rear section in. Finally got around to cutting console bracket out of old floor section and mocked up console. Console is in original location but required some trimming of the front section in order for it to set down. Also some notching on passenger's side where it sets on the upper cross member hoop. Trimmed console areas will be covered by the carpet "skirt" that wraps around the console. And I have two of these green consoles so I can hack one of them up without too much worry.
Finished welding rear section in. Finally got around to cutting console bracket out of old floor section and mocked up console. Console is in original location but required some trimming of the front section in order for it to set down. Also some notching on passenger's side where it sets on the upper cross member hoop. Trimmed console areas will be covered by the carpet "skirt" that wraps around the console. And I have two of these green consoles so I can hack one of them up without too much worry.