Classic auto air install 1970 Duster with 340 and Edebrock Super Victor EFI Manifold
So I figured out the vents un the above picture unscrew, so it's actually quite easy to deal with them.
For the middle, I bought an Autometer 2238 3 gauge panel and enlarged the outside holes to fit these, they are approximately 2.25"
I used the pods as-is on the left and right sides.
I had to move my inside hood release to make it symmetrical
Finally, the center with the AEM wideband gauge.
My friend who has a 3D printer is working on a tube to go past the steering column and also an insert for the controls. He has a 3D scanner also so this is a good test for that. Since he does this as a side business if we make something good it's possible they would be available for sale.
So I figured out the vents un the above picture unscrew, so it's actually quite easy to deal with them.
For the middle, I bought an Autometer 2238 3 gauge panel and enlarged the outside holes to fit these, they are approximately 2.25"
I used the pods as-is on the left and right sides.
I had to move my inside hood release to make it symmetrical
Finally, the center with the AEM wideband gauge.
My friend who has a 3D printer is working on a tube to go past the steering column and also an insert for the controls. He has a 3D scanner also so this is a good test for that. Since he does this as a side business if we make something good it's possible they would be available for sale.