What Carb for Poly Stroker
So I set the floats and locked off the choke by putting a thick washer onto the shaft where it pivots and tightening it down.
The floats were way off from what the manual specs are. There are 2 settings. First you have to set them with the top of the carb upside down. I set them at 7/16". Then you turn it over and set the hang. I set them at 1".
It's all a bit imprecise for my liking, bending arms and tabs. I'd prefer a solid arm and a screw adjustment but I suppose they are all like this, it's the first time I've done this. I just think bending metal leads to fatigue and possible changes over time.
So I set the floats and locked off the choke by putting a thick washer onto the shaft where it pivots and tightening it down.
The floats were way off from what the manual specs are. There are 2 settings. First you have to set them with the top of the carb upside down. I set them at 7/16". Then you turn it over and set the hang. I set them at 1".
It's all a bit imprecise for my liking, bending arms and tabs. I'd prefer a solid arm and a screw adjustment but I suppose they are all like this, it's the first time I've done this. I just think bending metal leads to fatigue and possible changes over time.