'69 Barracuda T56 swap, floor, cross member
I hooked the hydraulic clutch line to clutch master cylinder bled out clutch. Has a nice solid feel to it. Only around 3/8" of play at the top then it starts to push on pressure plate. No leaks seems to work consistently.
Got my 29 spline 1350 pinion yoke with straps and new seal. I have an 8 3/4 489 case which was bought from Randys Ring and Pinion as a complete 3'rd member 15 years back or so with 7290 yoke on it. Will be looking to maintain pinion bearing preload measuring before and with tires and brake drums off the car, sneak up on preload by slowly tightening pinion nut, measure preload, repeat, etc etc.
Once I get that yoke swapped then measure get drive shaft ordered. Then we are going to start to see the 6 speed part of the build make some real progress......
I hooked the hydraulic clutch line to clutch master cylinder bled out clutch. Has a nice solid feel to it. Only around 3/8" of play at the top then it starts to push on pressure plate. No leaks seems to work consistently.
Got my 29 spline 1350 pinion yoke with straps and new seal. I have an 8 3/4 489 case which was bought from Randys Ring and Pinion as a complete 3'rd member 15 years back or so with 7290 yoke on it. Will be looking to maintain pinion bearing preload measuring before and with tires and brake drums off the car, sneak up on preload by slowly tightening pinion nut, measure preload, repeat, etc etc.
Once I get that yoke swapped then measure get drive shaft ordered. Then we are going to start to see the 6 speed part of the build make some real progress......