Help - Adjusting ‘67 904 console floor shifter
Watch the clocking - red
And length - green
View attachment 1716188675
Spent some time battling the Barracuda today. As best as I could measure, the torque shaft lever has 3” of travel between 1 & P. The trans shift lever has 2 1/8” travel between 1 & P. All measurements would have been more accurate and easier if the trans was not installed.
The lever (A) on the torque shaft is about 3 1/2” from shaft to center of hole. The best measurement I got for the trans selector lever (B) is about 2 1/4” shaft to center of hole. Therefore the trans selector lever is about 1” shorter than the torque shaft lever.
The trans shift select lever looks like the 2 on the right in the photo, but no length is given.
Shouldn’t the levers be about the same length?
Do you know the lever lengths of the the levers in the photo?
I’m thinking my shift lever is too short (story of my life).